A before-and-after showing how we turn dense, hard-to-follow instructions into clean, jobsite-ready steps — and where the parametric "per-configuration" future goes.
What this is: an illustrative sample on a representative wall-cassette install sequence, to show the method and the output quality. The moment we have Låda's actual manual file, we run it through the same process and this becomes your real, branded document. Nothing here is pulled from Låda's source content.
Example section: setting the first wall cassette
● Before — typical manual
After the base track has been fastened to the slab and checked for level, the installer should bring the first wall cassette into position making sure it is the correct one per the plan and oriented correctly, then it is lifted into the track and pushed against the corner being careful not to damage the edges or the pre-installed electrical, and then it should be plumbed and temporarily braced before fastening through the designated points, and the connection to the next cassette is made using the supplied connectors, and electrical continuity should be verified, and all of this should be done by qualified personnel following local code and the connectors must be torqued appropriately and you should double check everything is plumb and square before moving on.
Confirm the cassetteMatch the panel ID label to the plan. Verify orientation arrow points outboard.
2
Set into the base trackLift, seat into track, slide to the corner. Keep edges and the pre-run electrical clear of the slab.
3
Plumb & bracePlumb with the 4-ft level; add one temporary diagonal brace before releasing the lift.
4
Fasten to trackDrive the 6 track screws at the marked points. Do not overdrive.
5
Connect & verifyJoin to the next cassette with the 2 connectors, torque to spec, then verify electrical continuity at the plug.
⚠ Stop & check: the wall must read plumb and square before fastening the next cassette — errors compound down the run.
◆ Per-configuration note: this project uses connector type C-2 and torque 18 ft-lb. (Auto-filled from the model — every project's manual shows its own parts & specs.)
Sign-off:
What the AI did here — and where it goes
Restructured a run-on paragraph into numbered, single-action steps a crew can follow without re-reading.
Surfaced the "at a glance" essentials (time, crew, tools, parts) up top, plus safety stop-points and a sign-off checklist.
Standardized voice and formatting — so every section reads the same across the whole manual, and translating to other languages is one click.
The payoff (Phase 3): because Låda is a kit-of-parts, the highlighted spec line gets auto-filled per project from the model — connector type, torque, panel IDs, exploded diagrams — so every job gets its own correct manual automatically, like IKEA instructions generated on demand.